Rancilio Silvia Mega-Mod part 14 Insulated wand
Avi's Silvia Mega-Mod
My way to a better coffee...
DISCLAIMER - Important!
The provided rubber sleeve is small and is not solving the matter as much of the wand is still unprotected.
Even adding 2 more rubber sleeves (as I did) still leaves unexposed hot areas.
Improving the insulation of Silvia’s wand was inspired from the wand design of high-end coffee machines.
It involves a double tube design in which an internal Teflon tube is inserted into the external metal one.
The internal tube is held in both sides of the wand with the help of O-rings that both centers and seals the ends. Adding the internal tube to Silvia’s wand is easy to do and in this page you’ll learn how I did it step by step.
1. 190mm (for V3 wand) Transparent FEP Teflon tube ID=2.0mm OD=4.0mm
2. 4x O-rings ID-3.1mm OD-6.35mm (any ID of 3.1-4.0mm will work)
3. 1x O-ring – ID-4.0mm OD-9.0mm
Make sure the tube end flattens with the last O-ring.
My 1 hole tip internal diameter is ~9.0mm, thus I have used the OD-9.0mm O-ring to center the tube.
When done installing the 4x O-rings, reassemble the metal tip.
Tip: Pay attention to the spring with its concaved part that meets the wand ball. Tighten the nut till you feel that the wand moves with your desired force.
As a result of using a smaller diameter internal tube, you got a better steamer. Pressure increases and steam supply duration got longer.
Enjoy your Cappuccino
Comments, remarks and updates are welcome.
Some will be published, with hidden sender's details.
Did you find this article helpful?
Did it save you time and trouble?
If yes, please consider donating some $$$ to help me cover the hosting cost involved. Thanks
To make a donation, please click the following PayPal button:
Copyright © Schneor Design. All rights reserved. Do not copy without written consent from the author.